But I'm pretty sure these are actually included anyway. uilding.md but adding to the default config (with make menuconfig) elo touchscreen serial and usb drivers. Compiled custom kernel mostly following these guidelines.MatchProduct "Elo Single Touch Device Input Module"Ī few things I did that I don't think I actually needed to do, but I'll list them here just in case the above fails MatchProduct "EloTouchSystems,Inc Elo TouchSystems 2216 AccuTouch® USB Touchmonitor Interface" I also just came across another calibration tool called evtest, look in my reference section for a link to a guide on that method The method I used is xinput-calibrator, so that's what I'll put here. One that I've tested and another that I just came across. Now that the screen is displaying, you may find that you need to calibrate it because the touches are inverted or just way off or whatever. #Adjust hdmi signal level (Can be tweaked if there's interference, default value was 2, default boost was 4, max value is 11) #Set the resolution to 800 x 600 at 75 HZ and allow audio (For a chart of hdmi mode resolutions see, I chose 800 x 600 because I'm using a 15" screen and this makes for bigger touch buttons and the program I'm using fits best on the screen at this res)
Code: Select all #Make the screen not go over the edges
0 kommentar(er)
